Adding Calibration Standards to TRIOS Software
Overview In this Tech Tip, we will show you how to add a calibration standard to TRIOS software. Calibrations are obtained by comparing the literature values of known standards to the measured ones in the calibration experiment. Standards’ melting, curie, Cp, and CTE values are used for different calibrations on thermal instruments. Here we will…
Rheology for Topical and Personal Care Formulations
Rheology for Topical and Personal Care Formulations
Discovery HR Packing Instructions
Following the packing and unpacking instructions of your instrument is important to the lifetime and performance of your instrument.
Discovery HR Unpacking Instructions
Following the packing and unpacking instructions of your instrument is important to the lifetime and performance of your instrument.
How to Correct Heat Flow for Large Ambient Temperature Fluctuations – Part 2
Overview In this Tech Tip, we will demonstrate how to calculate the filter time constant and heat flow dependency factor, which are needed to optimize baseline performance when large ambient temperature fluctuations are present.
How to Correct Heat Flow for Large Ambient Temperature Fluctuations – Part 1
Overview In this Tech Tip, we will demonstrate how to set up the TAM IV to optimize baseline performance when large ambient temperature fluctuations are present.
Thermal Analysis in the Pharmaceutical Industry: Use of TGA, SA, and DSC in Research, Development, and Quality Control
Thermal Analysis in the Pharmaceutical Industry: Use of TGA, SA, and DSC in Research, Development, and Quality Control
Setting Up a Compressibility Test Using the Powder Rheology Accessory on the DHR
Overview In this Tech Tip, we will show you how to set up a Compressibility Test using the Powder Rheology accessory on the DHR.
Setting Up the Powder Flow Cell with Temperature Control on the DHR
Overview In this Tech Tip, we will show you how to set up the Powder Flow Cell with temperature control on the DHR.