Preparing a Smart-Seal Pan for the Discovery TGA
Overview In this tech tip, we will show how to prepare a sample for use in a TGA Smart-Seal Pan.
Calibrating the Film/Fiber Probe on the TMA 450
Overview In this Tech Tip, we will calibrate the Film/Fiber Probe on the Discovery TMA 450.
How to Run an LED-PCA Experiment on the Discovery DSC
Overview TA Instruments – Waters Corporation’s state-of-the-art LED Photocalorimeter Accessory (LED-PCA) allows for the comprehensive study and characterization of photocurable materials across a broad temperature spectrum.
Installing the LED Photocalorimeter Accessory for the Discovery DSC
Overview In this Tech Tip, we will install the new Photocalorimeter Accessory (LED-PCA) on the Discovery DSC.
Adding Calibration Standards to TRIOS Software
Overview In this Tech Tip, we will show you how to add a calibration standard to TRIOS software. Calibrations are obtained by comparing the literature values of known standards to the measured ones in the calibration experiment. Standards’ melting, curie, Cp, and CTE values are used for different calibrations on thermal instruments. Here we will…
Preparing an Indium Sample for Cell Constant & Temperature Calibration
Overview In this Tech Tip, we will set up cell constant and temperature calibration on the Discovery DSC and prepare an indium sample for the calibration.
Selecting Experimental Parameters for Modulated DSC
Overview In this Tech Tip, we will give a general overview of the parameters you need to select when running a modulated differential scanning calorimetry experiment, also known as MDSC.
DHR Solid Polymer Torsional Analysis – TRIOS Polymer Guided Methods
Overview In this Tech Tip, we introduce the new DHR Polymer Torsional TRIOS Guided Method.